Changes to this Step
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Z Tower |
|---|---|
| + | [* 1] There are 3 towers for the Artemis. 1 of the towers has the extruder and hot end whip pre-installed. For this step you can choose either of the remaining 2 towers to be the Z tower. |
| + | [* 1] Locate the Z Tower Wire pack. Remove the wires from the pack and straighten them out. Be careful not to lose any of the connectors from the pack. |
| + | [* 1] The connectors shown will be in the top of the machine (the side with the stepper motors). |
| + | [* 1] Please orient so that you have the wires in the orientation shown. |
Image 1
No previous image
Added