Changes to this Step
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
| [title] Configure Extruder 1 | |
| [* 1] Set nozzle size to 0.5 *This is our stock nozzle size, if you are using a different nozzle size, put the correct nozzle size here* | |
| [* 1] Set filament size to 1.75 | |
| [* 1] In "Extruder End G-Code" match in the picture. You will add the line "G1 X0 Y80 F20000" | |
| [* 10] This is where knowledge of the printer comes in. The extruder end G-Code is used to move away from the print to swap filament. If your print is in this area, use a different X / Y coordinate to avoid any ooze on your print. | |
| + | [* 1] Click the tab labeled Extruder 2 to continue to next step. |