Changes to this Step
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
| + | [title] Configure Printer |
|---|---|
| + | [* 1] You will need to configure your printer on this page. The box in blue notes settings that are specific to your machine type (These settings are noted below for each machine.) The boxes in red should be set as shown in the image . The box in orange should be set to 2 for dual extrusion. |
| + | [* 1] The box in green should match for any machine using Duet electronics (Artemis and Rostock Max v3.2). If using rambo electronics the green box should match EXCEPT the line "M203 Z30000". |
| + | [* 1] Artemis 300 Settings: X 290 Y 290 Z 540 |
| + | [* 1] Rostock Max v3 and v3.2 Settings: X 265 Y 265 Z 400 |
| + | [* 1] Click Extruder 1 to proceed to the next step. |
Image 1
No previous image
Added