Difficulty
Very easy
Steps
2
Time Required
00:20:00
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
Private
This guide will not appear in search results and can only be viewed by team members!
Quiz
0
Tools
Parts
No parts specified.
-
-
First, click here to read safety information . This safety information may be updated at anytime so occasionally check for updates.
-
NOTE: This guide is intended to be followed online in order to fully utilize the links and documentation found within.
-
-
-
This is a lot easier to do if you unplug the 10-pin SL connector from the front of the hotend, and remove your PTFE tube from the PTC fitting. Both are indicated by the red arrows in the picture.
-
Carefully pull the power/thermistor splitoff down towards the arm of the hotend board and zip tie in place as indicated in the photo.
-
Make sure your cables are still plugged in properly under the flexible boot. If the bend is too tight, you might need to carefully snip a little of the boot off to give yourself some more room to bend the wires in place.
-
