Difficulty
Moderate
Steps
3
Time Required
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
User-Contributed Guide
This guide is not managed by the site's staff.
Private
This guide will not appear in search results and can only be viewed by team members!
Quiz
0
-
-
The photos in this step show you the hardware you'll need before you can begin work.
-
Image #1 shows the three #6-32 thumbscrews, 1" threaded standoffs and the three #6-32 x 3/8" screws used to attach the standoffs to the effector platform.
-
Image #2 shows the required male & female JST connectors that will be used to wire up the PEEK and layer fans.
-
Image #3 shows the 4 pin latching connectors that are used to wire up the hot end power and thermistor connections.
-
-
-
Cut the Layer fan wires where you soldered them together during the build. Mark the ends coming from the wiring loom as "Layer" so you can identify them later.
-
Cut the PEEK fan wires where you soldered them together during the build. Mark the ends coming from the wiring loom as "PEEK" so you can identify them later.
-
Measure 1-1/4" from the top of the melamine hot end mount and cut the four wires leading to the hot end.
-
Using your Phillips screwdriver & 5/16" wrench, remove the three screws that hold the hot end to the effector platform.
-
We're now ready to start adding connectors!
-
-
-
Insert wisdom here.
-
