You're viewing a previously published revision of this guide.  View latest revision

Older
May 03, 2018 - 06:05:01
Aug 10, 2018 - 08:08:18 May 04, 2018 - 04:05:33 May 03, 2018 - 07:05:22 May 03, 2018 - 06:05:00 May 03, 2018 - 06:05:49 May 03, 2018 - 06:05:38 May 03, 2018 - 06:05:52 May 03, 2018 - 06:05:34 May 03, 2018 - 06:05:24 May 03, 2018 - 06:05:51 May 03, 2018 - 06:05:35 May 03, 2018 - 06:05:25 May 03, 2018 - 06:05:47 May 03, 2018 - 06:05:01 May 03, 2018 - 06:05:17 May 03, 2018 - 06:05:05 May 03, 2018 - 06:05:02 May 03, 2018 - 06:05:47 May 03, 2018 - 06:05:40 May 03, 2018 - 06:05:10 May 03, 2018 - 06:05:02 May 03, 2018 - 06:05:46 May 03, 2018 - 06:05:36 May 03, 2018 - 05:05:46 May 03, 2018 - 05:05:27 May 03, 2018 - 05:05:38 May 03, 2018 - 05:05:28 May 03, 2018 - 05:05:50
Newer

DUET Change Stepper Motor Steps/mm

Written By: SeeMeCNC (and 2 other contributors)
  • Comments: 4
  • Favorites: 0
  • Completions: 7

Difficulty

Moderate

Steps

2

Time Required

Suggest a time??

Sections

1

Flags

0

Quiz

0

  1. 1. Goto Settings

    • 1. Goto Settings

    • 2. Then System Editor

    • 3. Click on config.g

  2. Change values of these two lines starting with "M92 ....."

    • Change values of these two lines starting with "M92 ....."

    • 1.8 degree stepper settings:

    • M92 X100 Y100 Z100

    • M92 E91.0:91.0

    • 0.9 degree stepper settings:

    • M92 X200 Y200 Z200

    • M92 E91.0:91.0

Author

with 2 other contributors

SeeMeCNC

Member since: 10/4/16

562,208 Reputation

16 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 1

All Time: 2,537