Assembling the Flexible Resin Resevior

Take extra care with the FEP film to prevent scratching either side. When not using the FEP film you should lay it on a protected surface such as a paper towel or CLEAN shop towel.

The FEP sheet is pre-cut by SeeMeCNC and therefore has masking to protect the surface. Remove this mask by peeling off from one corner. Do not rush this process, you do not want to create any creases in the FEP film.

After you have removed the masking, lay the FEP film on a paper towel or CLEAN shop towel and use Isopropyl Alcohol to clean the surface of both sides. (Lens cleaning wipes would also work well)

Lay the FEP film on top of the VAT base as show in the image (note: the nut traps should be down against the table) Orientation of the FEP film does not matter, the part is symmetrical)

Lay the VAT Tension Ring on top of the FEP film. (Not this part is symmetrical in all aspects so orientation does not matter.)

Use (12) 6-32 x 1/2" Socket Head Cap Screws and (12) Nylon Lock Nuts to attach the tension ring to the FEP file and VAT base. Start with the four corners and then continue with the rest. Note the locations of the (12) 6-32 x 1/2" Socket Head Cap Screws in the image.

Tighten all 12 of the (12) 6-32 x 1/2" Socket Head Cap Screws

For this installation, note the orientation in the image. This is not particularly critical, and is based on user preference. If you are assembling this for the DropLit v2, this will put the resin pouring spout in the back left corner (as designed)

Lay the VAT Top Plate on top of the FEP film. Insert (2) (12) 6-32 x 5/8" Socket Head Cap Screws into the holes on one of the long edges of the piece. You will need to tilt the piece in order to get the screws started threading into the Nylon Lock Nuts.