Help
Matthew Weber
@mw3dreefer
Matthew Weber
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 04/09/2018 | |
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 04/09/2018 | |
I would suggest moving the motor mounting, and belt routing to be done BEFORE mounting the duet panels, duet, and side plates as this allows MUCH easier access to the screws for final tensioning of the belts. Unless using a stubby screw driver the side plates especially get in the way to access 2 of the 4 motor screws for final tightening.
The inventory list font i also would suggest increasing. This became the biggest issue since being such fine font size, i couldnt make a quick inventory and realize that one 84407 plate was missing before i started a 13 hour live stream build of the Rostock.. Didnt look good for SeeMeCNC to end up short a part on a $1000 kit. Even if just numbered the bags instead of individual parts lists in them, with a corresponding full page print out of what each numbered bag contains.