Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 35 —

Step Type:

Drag to rearrange

NOTE: Conversion kits shipped after 09/18/2018 DO NOT include the fuse holders and fuses as the fuses are now built into the Duet board and these are no longer needed.

The Fuse holders in your kit already have the fuse inside of them. You will need to open the Fuse holder to see which one contains the 5A Fuse and 15A fuse.

Install them into the corresponding laser cut holes on the side panel.

Now Pre-Tin the 4 prongs on the back side of the Fuse holders and one end of the 12awg black wire and one end of the 18awg red wire found in your kit. Also cut the two lengths of heat shrink in half.

Your contributions are licensed under the open source Creative Commons license.