Skip to main content
Editing Step 25 —

Step Type:

Drag to rearrange

Image one shows the common terminal locations on the Duet board. Please reference this when preparing for wire installations.

When inserting the wires in the white Molex KK connectors, make sure you're using the connectors we sent you in the kit, NOT the ones included in the Duet box!

We will begin with the End Stop Wires. You must ensure that you get the correct end-stop plugged in with the corresponding location on the Duet Board. If not we will run into issues during later setup.

Then Secure the End Stop wires with a cable tie

Your contributions are licensed under the open source Creative Commons license.