SeeMeCNC Guides
/
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 18 —
Finished End Stop Wires

Step Type:

Drag to rearrange

Install the wires one tower at a time with one KK crimp going into the first Pin of the connector and the other going into the 3rd. Repeat this with all end stop wires.

After you have installed the end stop wires into the 3 Pin connector it is a good idea to mark which tower they go to by writing X,Y,Z on the connectors

End Stop Wires have no polarity so it does not matter which wire goes into which spot. As long as they are in the first and third Pin.

Your contributions are licensed under the open source Creative Commons license.