SeeMeCNC Guides
/
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 14 —
TRIM END STOP WIRES

Step Type:

Drag to rearrange

Next step is preparing your end stop wires for the Duet3D-WiFi board. Start by trimming the wires down to length. Pull the wires to the opposite edge of the Laser Cut Plate and snip the off excess.

Do Not Worry if your end stop wires are not long enough to be cut to that length. You will soldering on new end stop leads that will be plenty long enough.

Your contributions are licensed under the open source Creative Commons license.