1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
Plug in the power cable to printer.
Turn the printer on.
The hot end should light up, as well as the status LEDs on the Duet board.
We will now move on to the initial connection and setup.
Go Here Next > Configuring Rostock Max v3.2
If you did not use the 0.9 steppers and/or the 16 tooth pulleys, go HERE to adjust the steps per mm after configuration.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help