Help
Editing Step 35 —
Bowden Tube Routing

Step Type:

Drag to rearrange

The Bowden tube is carried inside the mesh loom that holds the hot end wiring.

The PTFE will enter the mesh loom approximately 90mm below the extruder. Open a gap in the mesh by pressing two areas about 1" apart toward each other. This will expand the loom.

Insert the Bowden tube into this opening and thread it through the loom until it reaches a point about 225mm from the end of the hot end connector.

Open the loom as you did previously and thread the Bowden tube through the exit provided.

Your contributions are licensed under the open source Creative Commons license.