Skip to main content
Editing Step 4 —

Step Type:

Drag to rearrange

The Y tower is the extrusion that has one red wire run through it.

Route the wire through the base top plate as shown.

Insert the extrusion into the base top plate, and then through each set of the TSLOT hardware. You will need to have the TSLOT nuts in a vertical orientation to be accepted by the extrusion. You also may need to loosen the TSLOT nuts if you have them too tight.

Upon seating the extrusion, you should route the wires around the idler plate as shown and tighten the (4)1/4-20 button head screws.

Route the wire as shown.

Your contributions are licensed under the open source Creative Commons license.