The hardware and the firmware are now set up and ready to go! Now its up to you to do some experimenting with your preferred slicing engine to print all things (in dual filaments)
We have done beta testing in both MatterControl and Cura with positive results.
Note to users: T0 is the original extruder, T1 is the new extruder. Issuing T0/T1 will switch to that extruder and make it active.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.