1
2
3
4
5
6
7
8
9
10
Install the new extruder plate on the side of the machine using the original 10-32 fasteners.
Route the new stepper motor wires as desired in the top frame of the printer.
Plug the new stepper motor into the E1 position on the RAMBo board. The original stepper motor should still be plugged into E0.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help