Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 42 —

Step Type:

Drag to rearrange

The Whip wires are prepared for the RAMBo board, but the H2 is equipped with the Mini-RAMBo. We will have to modify 4 wires to compensate.

The first step is to locate the 10 Position 2X5 Connector. Then isolate the 26awg red, black, and blue wires from the whip. The ends of those wires will have connectors pre-installed. You will need to cut the connectors off of the wires.

Strip approximately 3mm of insulation off of each of the wires.

Slide some heat shrink tubing down over each of the 3 wires.

Your contributions are licensed under the open source Creative Commons license.