Skip to main content

Site Navigation

Your Account

Choose Language

Editing Step 41 —

Step Type:

Drag to rearrange

Locate the (6) Orion Arms (blue) and the (6) arm tension springs. *** You must start with the blue Orion Delta arms even if you intend to print using the black Rostock Max Arms ***

Begin by inserting 1 tension spring between 2 arms. Install those two arms onto the ball joints. You should feel a gentle snap, that is the indication that the arms are fully seated. Repeat for the other 2 sets of arms.

Identify the Z Tower. Insert a tension spring between the two arms at the end where the hotend will be installed. Install that set of arms on the hot end in line with the fan that is vertical (indicated with red arrows)

Complete the install for the remaining 2 sets of arms.

Your contributions are licensed under the open source Creative Commons license.