Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 40 —

Step Type:

Drag to rearrange

Locate the remaining ball joints and hardware from the arm pack.

Align the ball joint with the posts on the inside of the carriage and press on. You should attempt to evenly press the ball joint onto the carriage.

Secure the ball joint to each post using a #4 washer and a #4 x 1/2" sheet metal screw.

Repeat these steps for each of the three carriages.

Install the 4-40 x 3/4" screws into the top of the carriage as shown in the image. You should tighten the screw until you start to feel some resistance. At that point STOP and do not tighten any further.

This screw is the trigger for the end-stop. You can move the carriage up and ensure that is presses the button on the end-stop.

Your contributions are licensed under the open source Creative Commons license.