Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

Insert (2) nylon lock nuts into the "t" shaped cuts in base assembly top and bottom plates. The flats of the "t" shaped cuts will be against the flats on the nuts. Match the orientation for the nut (for the nylon insert) with that in the image.

Install (3)TSLOT nuts into the TSLOT. Align them as shown in the image.

In this step and all other steps using the TSLOT nuts, the boss (ridge) on the nut should be facing away from the head of the button head screw.

All of the horizontal plates are laser engraved with XYZ tower indicators. You are going to be installing all of these main horizontal plates in the orientation that puts the XYZ text face up.

Ensure that there are not any wires that will be pinched when installing the base assembly top plate.

Install the base assembly top plate. Fasten with (3) 1/4-20 button head screws. You can fully tighten these screws.

If you are having troubles getting the button head screws to engage the TSLOT nuts, first ensure that you have the nut aligned with the hole, second loosen the 1/4-20 button head screws slightly on the side plates.

Full tighten ALL of the 1/4-20 button head screws in all locations at this time.

Your contributions are licensed under the open source Creative Commons license.