Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

Locate the pack of (3)timing pulleys with set screws and the (6) 3.25" TSLOT Pieces.

Complete the following steps for each of the (3) base tower assemblies. Ensure that you match the (2) Z pieces and (4) XY Pieces)

Slide the TSLOT into one side of the plates as shown. You can loosely tighten the button head screw to keep it held in place. Do not tighten.

Install the timing pulley onto the stepper motor as shown in the image. (One of the set screws should be aligned with the flat on the stepper motor shaft). The face of the timing pulley should be flush with the end of the stepper motor shaft. Tighten both set screws fully.

Slide the opposite plate onto the TSLOT and loosely tighten the button head screw to keep it held in place. DO NOT TIGHTEN.

Perform the same operation noted above to attach the two sides of the top tower assembles.

Your contributions are licensed under the open source Creative Commons license.