Use the remaining 6-32 x 1" Phillips Pan Head Screw to attach the base to your current assembly.
You can now fully tighten all screws in the assembly.
NOTE: The two screws that act as a pivot point should not be so tight as to prevent the Mirror Mount Assembly top section from pivoting about the bottom section.
Set the entire sub-assembly and remaining parts from this sub-assembly aside for installation later in the build.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.