1
2
3
4
5
6
Connect the USB cable to the Raspberry Pi and the 3D Printer
Choose: GCODE - Marlin firmware (even though we are using Repetier Firmware)
Set the Baud Rate to: 250000
Click Connect
Success! You have now got everything set up. If you have not already you can disconnect from the AstroBox local network and connect back to your own wifi network
Click on Start Printing to get stared.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help