1
2
3
4
5
6
7
8
9
10
11
12
13
Now you still have the long tabs to crimp down. I found it easiest to cut these tabs in half using a small pair of precision cutters and using needle nose pliers to bend the tabs over slightly. Then I used my crimping tool to complete the crimp as seen in Pic 1.
With both wires crimped, you will get the rubber boot for the new plug as shown in Pic 2.
Insert the wires and loom into the boot and slide the boot up the whip as shown in Pic 3.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help