1
2
3
4
5
6
7
8
9
10
11
12
13
We will now be working near the 10 pin plug. Slde the boot up and out of the way to work in this area as shown in Pic 1.
Using something like needle nose pliers, you will reach into the loom in the gap where all the wires for the 10 pin plug come out and grab the white wires and start to slide them out as shown in Pic 2.
Slide the thermistor wires all the way out of the loom to exit the same area the wires for the 10 pin harness come out as shown in Pic 3.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help