1
2
3
4
5
6
7
8
9
10
11
12
13
Slide the rubber boot up off the 10 pin connector as shown in Pic 1. Unclip the 10 pin connector from the SE300 board.
Slide up the rubber boot from the power connector and the thermistor plug as shown in Pic 2. Unplug both of these connectors and this will remove the whip from the hotend.
Unclip the arms from the hotend platform and remove the hotend from the machine.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help