1
2
3
4
5
6
7
8
9
10
11
12
13
First you will be removing the hotend from the Printer. Remove the lanyard clip from the PTC clip as shown by the arrow in Pic 1.
Once unclipped, press down on the black ring on the PTC adapter and slide the PTFE tube out of the hotend as shown in Pic 2.
Cut and remove the Zip tie holding the whip to the SE300 board as shown in Pic 3.
« Introduction
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help