1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Pass the silicone heater wires through the existing plastic bed insulator as shown.
Strip the wires from the heater and attach one of the wires to the black wire leading from the SSR terminal number 2, using the 26228 Splice Conn. Insul. 10-16AWG Crimp connector
Attach the other white wire to the white wire leading from N on the power supply
Plug in the SL connector you installed on the thermistor leads to the SMC-T1 thermistor board
Apply electrical tape to the white wires coming from the silicone heater as shown to cover the wires when folded back towards the bed.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help