Clean the back of the aluminum heat spreader with alcohol and a paper towel.
Peel the backing off of the adhesive on the 58801 Silicone Heater 300mm Dia 350W REV B
Apply the heating pad, aligning the three notches with the deeper grooves on the heat spreader, and the white AC wires exiting from the right of the bed, as shown in the photo.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.