Close other applications that may use the USB com port.
This printer is NOT designed to run from the USB port. Only connect the USB cable during setup of the printer.
The printer is designed to run from either (a) browser window over your intranet or (b) by addition of touchscreen with SD card reader
Close Cura, Mattercontrol, or other slicers you may have open.
Close any non-3D related programs, like Arduino or other programs that may use the USB com port.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.