Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 190 —

Step Type:

Drag to rearrange

Insert the loop of the lanyard over the top PTFE tube as shown in Pic 1.

Insert the PTFE tube into the extruder fully till it stops near the hobbed drive gear as shown in Pic 2.

Insert the clip side of the lanyard under the black clip of the PTC connector on the ezr struder as shown in Pic 3.

After the lanyard is installed in the PTC connector, give the PTFE tube a strong push further into the ezr struder to fully seat it.

Your contributions are licensed under the open source Creative Commons license.