Editing Step 188 —

Step Type:

Drag to rearrange

Approx. 7 inches from the top of the machine, you will be putting the PTFE tube inside the covering for the hotend whip.

The covering is a mesh, so you will work the PTFE tube into the mesh with the wires.

Manually lower the hotend to the center of the bed all the way down.

Work the PTFE tube through the mesh of the hotend whip and poke it out of the mesh approximately the same height as the carriages with the hotend at the bed as shown in Pic 3.

Your contributions are licensed under the open source Creative Commons license.