Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 158 —

Step Type:

Drag to rearrange

Insert the 4x M3x10mm long phillips screws through the ezr struder into the motor. Tighten these screws snug but do not fully tighten yet.

When all 4 screws are snug, as seen in Pic 3, apply pressure to the red lever on the ezr struder.

While applying pressure to the red lever, fully tighten the 4 screws to secure the ezr struder to the motor. This will make sure the plastic parts are aligned properly.

Your contributions are licensed under the open source Creative Commons license.