Editing Step 147 —

Step Type:

Drag to rearrange

Insert the wires past the wire covering into the cable hub.

In Pic 2, you want to align the cover for the 10 pin connector on the wires to the left side of the Y tower. This will set the distance of the whip to the proper length.

The top of the 10 pin boot should be lined up with the top of the lower frame next to the Y tower.

Use a pair of pliers to tighten the large section of the cable hub to tighten the hub to the whip and secure it in place as shown in Pic 3.

Your contributions are licensed under the open source Creative Commons license.