Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 115 —

Step Type:

Drag to rearrange

This section will use the 3 idler brackets with motors installed that were made at the beginning of the guide. You will also use 3 small shims, 6x 6-32 x 7/8" long philips screws, 6x black endstop wires with pre-crimped connectors, and 3x 3 pin white connectors.

Insert the crimped end of 2 wires into a white connector as shown in Pic 2. The crimp will push fully into the connector until you hear a click to lock it in.

There are going to be 2 wires going into the 3 pin connector. The positions on the connector to use are the outermost locations. There will be NO wire in the center position of the 3 pin connector!

Repeat this process with the other wires so you have 3 pairs of wires with a 3 pin connector on them as shown in Pic 3.

Your contributions are licensed under the open source Creative Commons license.