Skip to main content
Editing Step 92 —

Step Type:

Drag to rearrange

This step will use the lower sheet metal, the 60mm x 60mm x 25mm fan from the electronics pack, 4x M3 x 35mm long phillips screws from the lower hardware pack, and 4 o-rings from the lower hardware pack. You will also need 4x M3 nylon lock nuts and 4 washers.

Cut off the white plug from the fan as close to the plug as possible and discard this plug as shown in Pic 2.

Strip about 10mm of the ends of each wire from the fan as shown in Pic 3.

Your contributions are licensed under the open source Creative Commons license.