Editing Step 85 —

Step Type:

Drag to rearrange

This step you will need the Heated bed with aluminum heat spreader, the remaining M3 x 10mm long flat head screw, #4 washer, and the thermistor setup you made in the previous step.

Using the bottom most hole on the bed that is by itself, insert the screw through the washer and through the bed and screw it into the thermistor holder as shown in Pic 2.

The first pic shows a different connector on the thermistor. This has changed and you will have the plug in board connected instead as the assembly has been updated for a more reliable connection.

Your contributions are licensed under the open source Creative Commons license.