Editing Step 21 —

Step Type:

Drag to rearrange

Set the motor to the counter clockwise location as shown in Pic 1. The screws should be snug enough to hold its position, but loose enough you can rotate the motor along the slots.

Using the small bracket, align the pegs of the large bracket to attach the halves together. The pegs will go into the idler bearings to align.

Using 2 sheet metal screws, insert one screw in each hole of the small bracket circled in Pic 3.

Repeat this on all 3 brackets.

Your contributions are licensed under the open source Creative Commons license.