1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Put another locking clip on the PTFE tube, and insert the tube into the extruder.
Install the locking clip as you did on the previous step to lock the tube in place.
As before, after the clip is installed, press the tube further into the extruder to fully seat it.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help