1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Locate the new PTFE liner that came in the kit. (Figure 1)
NOTE Figure 2! The liner has a taper on one side of it, you MUST have this taper facing up towards the circuit board side of the hotend!
Insert the PTFE liner with the taper side up into the hotend. See Figure 3.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help