1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
For this step we will need the Spool hanger (large injection molded plastic piece), Stainless steel insert, Threaded screw and 2 washers.
First insert the stainless steel insert into the spool hanger in the side shown in Figure 2.
Place one washer on the threaded screw and insert the screw into the stainless steel insert as shown in Figure 2.
Place one washer on the other side of the spool hanger on the threaded screw as shown in Figure 3.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help