1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Approximately 2.5" above the hole, Insert one of the two extruder hangers on the left side of the rail when viewing it from the outside as shown in Figure 1.
Rotate the hanger clockwise to lock it in the rail and tighten the screw as shown in Figure 2.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help