1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Tape the end of the motor wires included in the kit to the end of the filament as shown in Figure 1.
Make sure to cover the metal plugs at the end of the wire so it will not catch on anything inside the tower.
While feeding the wires from the bottom, pull the filament out from the top slowly until you pull the wires out of the top as shown in Figure 2.
After you have pulled a length of the wires out of the top, you can remove the tape from the wires and filament. Discard the filament.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help