1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
On the Y tower remove the black plug on the face of the extrusion.
Cut a length of filament about 4 feet long. Long enough to reach from the hole in the extrusion to the top of the machine with extra.
Feed the filament into the hole on the side of the extrusion and up to the top and out as shown in Pictures 2 and 3.
« Introduction
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help