Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #32

Edit by Nick Kessler

Edit approved by Nick Kessler

Before
After
Unchanged

Step Lines

[title] Belt Installation
-[* black] For the step you will want to lay the printer on its side. Being careful not to pinch the SE300 Whip or the two remaining uninstalled wires. Also remove the 3 pieces of black acrylic from the base.
+[* black] Thread the belt back up the tower and over the top idler bearing and back into the other side of the tower. Now pull the belt up over the timing pulley and it should look like the first picture.
+[* black] Make sure the belt is on the base idler bearing.
+[* black] Now thread the belt through the top of the carriage and ramp it up through the hole with a small flat head screw driver. Once you enough belt through the carriage to clamp, install the Belt Clamp that you removed in the beginning. Do this for all three towers.
+[* icon_note] Do not worry if your belt is loose, you will tension them in the next step.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added