Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #20

Edit by Nick Kessler

Edit approved by Nick Kessler

Before
After
Unchanged

Step Lines

[title] Installing the 3D Printed Duet Wifi standoff
-[* black] The next step is installing the 3D Printed Duet Standoff. For this step you will need your 3D printed Duet standoff, the 40mm fan with 2pin KK connector, the small hardware bag containing 10 screws, and the 4 Nylon washers from the Duet Connectors bag located in your Duet WiFi box
+[* black] Begin by lining up your 3d printed standoff with the existing Rambo standoff screw holes. Use the 4 #6x1/2"L screws provided and screw them up into the standoff from the bottom of the Laser Cut Panel.
+[* black] Now install the 40mm fan to the 3d printed standoff using the 2 M3-.50x14mm screws.
+[* black] Now line up your Duet Wifi board with the 4 top holes of your 3d printed stand off and tighten it down using the four 3/8" pan head screws and four Nylon washers. Do your best to keep the board as centered as possible.
+[* icon_caution] BE CAREFUL NOT TO OVER TIGHTEN ANY OF THE SCREWS INTO THE 3D PRINTED STANDOFF.