Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #18

Edit by Nick Kessler

Edit approved by Nick Kessler

Before
After
Unchanged

Step Lines

+[title] Finished End Stop Wires
+[* black] Install the wires one tower at a time with one KK crimp going into the first Pin of the connector and the other going into the 3rd. Repeat this with all end stop wires.
+[* black] After you have installed the end stop wires into the 3 Pin connector it is a good idea to mark which tower they go to by writing X,Y,Z on the connectors
+[* icon_note] End Stop Wires have no polarity so it does not matter which wire goes into which spot. As long as they are in the first and third Pin.

Image 1

No previous image

Added