Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #44

Edit by Andy Oprisko

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

[title] Perform Initial Power Up and Function Test
[* black] Plug in the power cable to printer.
[* black] Turn the printer on.
[* black] The hot end should light up, as well as the status LEDs on the Duet board.
[* black] We will now move on to the initial connection and setup.
[* black] ***Go Here Next >*** [guide|89|Configuring Rostock Max v3.2]
+[* black] If you did not use the 0.9 steppers and/or the 16 tooth pulleys, go [guide|101|HERE] to adjust the steps per mm after configuration.