Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #6

Edit by Andy Oprisko

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

-[title] Install Heater Cartridge
+[title] Disassemble Hotend Body
[* icon_note] The main body of the hotend will come finger tight. Do not use this as assembled.
[* black] First remove the nozzle (should only be on finger tight when taken from the kit). Then unscrew the heater block. Finally unscrew the heat break. You should have 4 seperate pieces.
-[* black] Insert the heater cartridge into the heater block with the legs of the wires coming out the direction as shown. The wires should be coming out the same side as the set screw for the thermistor as shown in pic 2.
-[* black] Tighten the screw to secure the heater cartridge in place. You can use a pair of pliers to hold the block in place while tightening the screw to secure the heater.
+[* black] You should have the body disassembled as shown in Pic 2.

Image 1

Old Version

New Version

Image 2

Old Version

New Version